Análisis de falla de pernos de acero
Cargando...
Archivos
Fecha
Título de la revista
ISSN de la revista
Título del volumen
Editor
Resumen
In this project the analysis of the failure of the two in a PVC plant in the GERFOR SAS plant is presented. These two bolts were taken to the laboratory of metals and heat treatments of the university liberators, to perform the study of fracture, which presents a transversal fracture. A transversal cut was made, it can be used with different sanding calibers and a chemical attack was carried out with 10% for a metallographic operation in a longitudinal section by means of an optical microscope at an image magnification of 100x, 200x, 500x and 1000x, On the other hand, a test of central, external and lateral hardness was performed on the rockwell scale, this was done in order to identify the type of fracture and steel, finally fracture was found by fatigue inside the bolt and beach marks. Where the fault began and the fracture occurred. (Apartes del texto)
Descripción
En este proyecto se presenta el análisis de falla de dos pernos que estaban situados en una tolva de pesaje que fijaban una celda ARC, en la planta de GERFOR SAS. Estos dos pernos fueron llevados al laboratorio metales y tratamientos térmicos de la universidad los libertadores, para realizarle el estudio de fractura, cual presenta una fractura transversal. Se realizó un corte transversal, se pule con diferentes calibres de lija y se realizó un ataque químico con Nital al 10% para una preparación metalográfica en una sección longitudinal mediante un microscopio óptico a un aumento de imagen de 100x, 200x, 500x y 1000x, por otra parte, se realizo´ ensayo de durezas central, externa y lateral en escala Rockwell, esto se realiza con el fin de identificar el tipo de fractura y el acero, finalmente se encontró fractura por fatiga en el interior del perno y marcas de playa donde se inició la falla y se produjo la fractura. (Apartes del texto)